Sentence examples for density of the test from inspiring English sources
Results are expressed as a ratio of the optical density of the test sample over that of a reference sample (cut-off for positivity is 1.1).
The results indicate that the maximum density of the test drilling fluid is 1.9 g/cm3, the single maximum footage is 1480 m, and the operation time of the tool is more than 200 h.
The optical density of the test sample and standard wells was determined spectrophotometrically at 595 nm using the Spectramax plate reader.
The test results show the relationship among the inflation exponent r, the density of the test graphs and the performance the LRW algorithm.
Figure 5 shows the influence an increasing simulation sample size N has onto the accuracy of the estimation of the density of the test statistic if the null hypothesis is true.
The percentage inhibition of hemolysis was calculated using the following equation: % inhibition of hemolysis = 100 × (OD1 − OD2)/OD1, where OD1 is the optical density of the hypotonic buffered saline solution alone (control) and OD2 is the optical density of the test sample in hypotonic solution.
The surface area density of the tested HTHE is 6 times higher than that of the bare bayonet tube heat exchanger.
The density of the tested binary ranged from 1375 to 1560 kg/m3; the strength appears to decrease as the density increases.
Figure 1: The p-value, represented as the shaded area under the probability density of the tested hypothesis $X \sim N 0,1)$, for observed data $x=1.8$$p=0.072$2$x=1.8$$p=0.072$
The extract effect to stimulate PBMC proliferation was calculated using the following formula: Proliferation % = ODt / ODc – 1 × 100 Where (ODt) indicates the optical density of the tested extract and (ODc) indicates the optical density of the negative control [ 18].
The concentration of the extract that killed 50% of the cells (IC50) was calculated using the following formula: Cytotoxicity % = 1 – ODt / ODc × 100 Where (ODt) indicates the optical density of the tested extract and (ODc) indicates the optical density of the negative control.
