Sentence examples for density of the solids from inspiring English sources

The density of the solids used in these processes is usually only slightly higher than the liquid density.

The results indicate that the density of the solids suspension was non-uniform in the cross section at a certain height, and decreased gradually with increasing furnace height.

Based on the principle of Buoyancy, the gravitational systems and the deciding factor for particle settling to take place, is the difference between the density of the solids and that of the suspending liquid.

Given the size and density of the solids - in the simple case of a unimodal distribution of spherical particles- and the density and viscosity of the liquid, it is argued that there is a critical value of the shear stress percentage for the lift force to overcome gravity.

The photonic efficiency of the supported photocatalysts depends extremely on the optical density of the solid suspensions.

The adhesive strength of HVOF cermet coatings will be increased with an increase in the density of the solid material component in the two-phase particle.

With added salt, the liquid density was adjusted to 1.0485 kg/m3 for matching the density of the solid phase which was 1.05 kg/m3.

Based on dimensional analysis and factorial design, correlations are developed using the system parameters, i.e. geometry of the bed (cone angle), particle diameter, initial static bed height, density of the solid, and superficial velocity of the fluidizing medium.

Using a wet packing method to measure the packing density of the solid particles in mortar, it was found that the addition of FAM could effectively increase the packing density and decrease the voids volume.

The influence of important variables associated with the design of distributors has been studied including the effect of the density of the solid particles on the distributor region flow behavior.

It is shown that the pseudo steady state approximation in the application of the shrinking core model to liquid solid reactions is valid even when the ratio of liquid reactant concentration to molar density of the solid is high.