Sentence examples for density of rods from inspiring English sources
The region surrounding the fovea is called the parafovea; it stretches about 1,250 microns from the centre of the fovea, and it is here that the highest density of rods occurs.
These mechanisms are implemented in a phenomenological equation governing the evolution of rod length, with the number density of rods appropriately modified to ensure conservation of surfactant mass.
Although the density of rods and the aspect ratio is known to increase when deposited from alcoholic solutions [46], the effect of the temperature cannot be overlooked either in the sense of an increased NBE intensity.
The rest of the retina will not be able to adequately compensate for the loss or compromise of the macula because the density of rods and cones is just too diffuse.
This limits the density of rods and cones, and so the partial fix is to have one small area cleared of nerves and blood vessels where rods and cones can be denser.
The density of rods was determined by averaging the quantities of rods calculated at three different areas on each sample with a total area size of 125 μm2 for each area, and then, the obtained value was normalized to square centimeters (cm2).
The increase in the filament temperature to 1450 °C and the high density of rod-like NiSi/Si nanowires is presented in Fig. 1b with the latter demonstrating a grainy surface morphology as seen in the inset.
The retinas of nocturnal birds, including nightjars, are adapted for sight in low-light levels and have a higher density of rod cells and far fewer cone cells compared to those of most diurnal birds.
An increase in the density of "rod cells," which are the elongated hematoxylin-stained nuclei, can occur with or without the formation of MGNs.
The density of ZnO rods decreases and the rod size increases with increasing Eu III) concentration in the bath.
The radiographic density of the rods can be estimated using the calibration parameters supplied by the phantom manufacturer, and simple linear regression calculations (Les et al. 1994; Schileo et al. 2008).
