Sentence examples for density of each sample from inspiring English sources

Equation 4 was used to calculate the carrier density of each sample.

The thermal conductivity, effective porosity, permeability, and matrix density of each sample was determined.

Optical density of each sample was recorded at 725 nm in a UV Vis spectrophotometer (HITACHI, U-2900) using Gallic acid as standard.

It is noted here that the actual density of each sample should be higher since the calculated quantity is not considering the unobservable rods of flower-shaped structures.

Afterward, 90 μl DMEM and 10 μl CCK-8 solutions were added to each sample, and after incubation at 37 °C in humidified 5%% CO2 for 30 min, the optical density of each sample was measured at 450 nm using an auto-microplate reader (Infinite M200, Tecan, Austria).

The optical density of each sample was determined using a microplate reader set to 450 nm (Biotrack, Pharmacia).

Therefore, we used the average wet bulk density of each sampling site for calculation of cosmogenic nuclide depth profiles.

The measurement used is the rate of change of the optical density for each sample (in terms of slope Absorbance/second; A/sec).

Figure 7 Variation of cell density for each sample.

Bulk density of each soil sample was then calculated using the following formula; B D sample = OD W sample / VAD.

Serum Sema3E concentration was determined by comparing the optical density (OD) of each sample to the standard curve.