Sentence examples for dense specimen from inspiring English sources

In the dense specimen, imperfections – indicated by the discontinuities in the field of vx and – are observed appearing in the stress hardening regime.

Dense specimen having the composition of 1 20 weight ratio of talc with respect to CoNiCrAlY was prepared using the Spark Plasma Sintering (SPS) technique.

To shed light on these topics, a dense specimen collection was performed in the center of the Iberian Peninsula – resulting in 28 new H. elisae collecting points, some of them as close as 760 m from each other- for a higher resolution of the distribution of the cryptic lineages and the relationships between the populations.

Dense specimens were prepared by spark plasma sintering.

The reduction in the densification rate reached a factor of ≈ 100 for a Y3+ concentration of 6 at.%. Creep of dense specimens was investigated at constant strain rates of 10−5 and 10−4 s−1 in air at 1200°C.

There was no influence of porosity on the reaction rate of beryllium in steam within the limited investigated density range, except at 700°C, where the measured reaction rate for the irradiated 97.2% dense samples is an order of magnitude higher than for the irradiated 99.9% dense specimens.

The microstructures and mechanical properties of the dense SLM specimens fabricated under the optimum laser irradiation conditions were also investigated.

The dense SLM specimens had an ultimate tensile strength, yield strength, and breaking elongation of 400 MPa, 200 MPa, and 12 17%, respectively.

This paper examines the re-use of one such sludge material, namely, fluoride contaminated bone char sludge, as partial replacement for fine aggregate (river-sand) in the manufacture of dense concrete specimens.

The samples were consolidated into highly dense bulk specimens at temperatures within the supercooled liquid region in order to take advantage of the viscous flow behavior of the glassy powder.

Pin-on-disc test with fully dense HIP specimens against flint, Al2O3 and SiC of 80 and 220 mesh size at room temperature revealed that the abrasive wear resistance of the new MMC with 10 vol.% in situ TiC particles, 63 100 μm in size and dispersed in a hardened steel matrix, was superior to a reference MMC with CrB2 and close to one with WC/W2C.