Sentence examples for degree thermal from inspiring English sources

However its high degree thermal coupling makes the control design a bottleneck problem, where data-driven model leads to obvious mismatch with the real plant in the high-purity control processes, and a first-principle model which is comprised of complex mass balance relations and thermally coupled relations could not be directly used as control model for the bad online computing efficiency.

Our simulations, with no adjustable parameters, show that atomistic simulation can capture non-trivial behavior of amorphous thermosets including the role of polymerization degree, thermal history, strain rate and temperature on the glass transition temperature (Tg) and mechanical response (including ultimate properties) and lead to predictions in quantitative agreement with experiments.

In Hamadan, as a typical example, there were approximately 2,000 second degree thermal burn victims to 30,000 and 14,000, respectively, for third degree and mass fire burn casualties.

Even around 8 kilometers (5 miles) you will suffer third degree thermal-burns; still at 32 kilometers (20 miles) the heat can burn the skin off your body.

The second phase of erythema is accompanied by the loss of the superficial layers of the epidermis: the skin appears similar to that observed in first-degree thermal burns.

The coal mass being researched was divided into three zones based on the degree of thermal erosion: strong thermal erosion zone, weak thermal erosion zone and no thermal erosion zone.

Here, we take advantage of the fact that the high degree of thermal energy in thermally denatured protein favors the denatured state to the extent that substantial amounts of either the denaturing osmolyte, urea, or the protecting osmolyte, sarcosine, can be present without populating the native state significantly.

This behavior has received a number of explanations, including a higher degree of thermal softening in the chip formation zone due to lower thermal conductivity of outer layer (TiN) coating, and high abrasive nature of ultra-hard particles present in the workpiece material such as chromium-carbide (Cr7C3), vanadium-carbide (VC), molybdenum-carbide (Mo2C) and iron-carbide (Fe3C).

Thermal performance during charging is presented in terms of the axial temperature distribution, the axial degree of thermal stratification, the total energy stored and the total exergy stored.

In the National Planning Scenarios [ 16], a lower degree of thermal impact was employed, which resulted in a somewhat less drastic outcome in the number of thermal burn casualties relative to that presented in this publication and in Harney's analysis [ 17].

This allows us to not only evaluate the degree of thermal comfort of the occupants in accordance with ASHRAE standards but also to carry out future comparisons between different thermal exchange system variants arising from the HVAC system.