Sentence examples for degree of spray from inspiring English sources

The atomizer is capable of generating finer drops at very high velocity with high degree of spray uniformity.

Furthermore, based on the contrast experimental results, the necessary and sufficient conditions for occurrence of the particle impact breakage behavior in the thermal spray process are: (1) the high brittleness of feedstock and (2) the high velocity and low melting degree of spray particles, respectively.

The results revealed that the equation ξ=1.21Re0.125 determined by the experimental data rather than other equations with the power factors of 0.2 and 0.25 to Reynolds numbers is applicable to reasonably estimate the flattening degree of the spray molten droplet in a wide range of the Reynolds numbers.

The parameter that expresses the degree of substitution of spray for gas is δ, the liquid loading, i.e., the ratio of liquid fuel mass fraction to overall fuel mass fraction in the fresh premixture.

Despite the spray drift modeling systems' high degree of accuracy, variable and incomplete spray application was expected at the edges of the modeled spray cloud (D. Markowski, pers.

However, a persistent seed bank is not formed in such a thin soil and only a small amount of seeds originate seedlings (A.D.C. and A.S.R., unpubl. res).. Plants then grow as vegetative rosettes for several years on cliff-tops and in nearby rocky areas with a high degree of exposure to salt spray and salt-laden winds from the Atlantic Ocean (Caperta et al. 2013).

The effects of increasing the phospholipids concentration on the degree of hollowness of the spray-dried particles are found to depend on the size and chemical nature of the nanoparticles.

WC Co coatings with low degree of decomposition were thermally sprayed by a high velocity oxy-fuel system from three agglomerated WC 12 mass% Co powders with different carbide grain size distributions.

Five samples showing the highest degree of restructuring were selected and spray coated with P25, a TiO2 photocatalyst, evaluating the mechanical stability of the coating with a standard tape test method.

A reduction of the heat input during spraying reduced the degree of WC decomposition and improved the coating properties when the spray powder contained a large fraction of small grains.

As compared to HVOF-spraying, the oxidation of particles can be significantly suppressed due to lower deposition temperatures, whereas, as compared to cold spraying, the degree of particle deformation upon impact can be enhanced by attaining higher particle temperatures.