They were then instructed to draw lines between the circles to indicate the degree of bond between each person, activity, or place.
However, some differences between the suction and degree of bonding of the samples taken from different locations might probably have been contributed to the separation of the bi-linear behaviour at different normal stress levels.
The fundamental difference between the transition states in the bimolecular and unimolecular mechanisms is the degree of covalent bonding between the nucleophile and the substrate in the transition state.
DSC states (Strong, Weak 1, Weak 2, and Free) and ATR FITR states (S0, S1, and S2) appear to correspond to the relative strength of the interaction and the degree of hydrogen bonding between the water and the polymer network, respectively.
However, by comparison, for TiO2 coatings with different phase structures, the degree of bone bonding between new bone and the R-TiO2/PEEK implant was significantly better than that between A-TiO2 and the PEEK implant.
This degree of bonding is useful for the definition of constitutive models for artificially structured materials.
Here adding one bond means increasing the degree of the bond between two atoms, hence a single bond becomes a double bond and a double bond becomes a triple bond.
This analysis showed that for beams with high corrosion degrees, the decrease in capacity is mainly because of the decrease in both the steel reinforcement cross-section and strength due to corrosion, whereas the major cause of strength reduction for beams subjected to low corrosion degrees is the loss of bond between steel and surrounding concrete.
The slight degree of hydrogen bonding that exists between the two polymers results in micro-phase separation without an excess degree of aggregation occurring.
