Sentence examples for degree of bands from inspiring English sources

Scores entered in matrix were analyzed using TAXAN version 4.0 software based on the degree of bands sharing.

The consequences of choosing a separation design focused on the degree of band overlapping are discussed based on the results of these optimizations.

The incidental oxidation of Ni in 1 M KOH electrolyte resulted in an increase in its work function that subsequently improved the effective barrier height of the composite system as well as the degree of band bending near the Si surface, thereby increasing the photovoltage with a value close to the conventional np+ Si buried junction.

The degree of band gap change was dependent on the doped elements and crystallite size.

When the gap was small (less than 20 bp), we reduced PCR product size (<120 bp) to increase the degree of band separation in agarose gel.

This is due to the fact that the flat band potential and the degree of band bending may be changed at the catalyst electrolyte interface in the presence of Fermi-level pinning effect [41, 42, 43].

So a high density of defects exists at the Au/NBT interface, where the high density of surface states induced by the defects may cause a large degree of band bending and then influence the validity of the metal/semiconductor contact rule in our Au/NBT/FTO heterostructures.

As for binding to the H19 ICR, the binding of BORIS isoforms to the CST probe was unaffected by alternative amino- and carboxy-termini, whereas the degree of band migration generally correlated with specific protein termini.

The mutated constructs showed varying degrees of band shift upon anisomycin treatment, with the S317A and T362A mutants showing minimal shift, indicating that these two sites are most responsible for in vivo phosphorylation induced MW shift.

There was also a degree of stutter bands associated with the main alleles of almost half of the markers used.

The great advantage Campbell's filters had over the RL circuit and other simple filters of the time was that they could be designed for any desired degree of stop band rejection or steepness of transition between pass band and stop band.