Sentence examples for deformation power from inspiring English sources
Critical-sliding prediction model includes Zhaitengdixiao model, Su aijun model, sliding deformation power model, gray displacement vector angle method, collaborative model.
A pine nut was loaded between two parallel plates to determine the rupture force, deformation, power and firmness required to initiate nut rupture.
A cyclic confining stress-dependent Mr test was also performed to determine the relationship between cyclic and confining stresses and Mr. Permanent deformation power modeling was used to estimate when the in situ cyclic loading response reached a near-linear elastic behavior.
Numerical results are presented to show the effect of nonlinearity, shear deformation, power-law index, microstructural length scale, and boundary conditions on the bending response of beams under mechanical loads.
Influence of deformation on power performance is determined implying on a reduction in output power.
The sintering was mainly promoted by the mechanisms of plastic deformation and power law creep during the continuous current discharge.
The obtained results thoroughly reveal the influence laws of the sizes of forming rolls on the average spread, fishtail coefficient, degree of inhomogeneous deformation and force and power parameters etc not only provide an important basis for design of the forming rolls and optimization of cold ring rolling process, but also reveal the plastic deformation mechanism of cold ring rolling.
The mathematical model has the form μ(t)="K(T I2{n(T -1}/2 where T -1}/22, n and K are termed the temperature, dynamic viscosity, the second invariant of the rate of deformation tensor, the powhereaw index and The consistency, respectively.
Based on Gaussian model for reflector antenna, the effects of localized wave-front deformation on received power are researched.
Subsequently, Mechanical Testing and Simulation (MTS) is performed with 40,000 load cycles, and the overall deformation of the power generation device is minimal and the electrical outputs of the piezoelectric energy-harvesting units remain stable.
Moreover, as the pre-loading temperature in RBC rose, the maximum curvature within the linear (MR) range occurred at greater deformation and lower power.
