Sentence examples for deflection of the structure from inspiring English sources

The initial stress defines the initial deflection of the structure while the Pd-hydriding induces compressive stress variation in the Pd actuator layer and therefore the membrane deflection.

The results show that increasing the CNTs volume percent, the dynamic deflection decreases while considering the CNTs agglomeration leads to increase in the dynamic deflection of the structure.

During normal operation, the maximum possible von Mises stress of the order of 62.4 MPa can be expected on the bottom heat transfer panel, and the corresponding deflection of the structure is of the order of 0.62 mm.

The influences of fluid, boundary condition, thermal load, moisture changes, boundary condition, structural damping parameter, length to thickness ratio of shell, CNTs volume percent and agglomeration are shown on the dynamic deflection of the structure.

Fig. 8 The deflection of the structure of a robot for different heights and middle leg's positions.

Here the unknown variables (u x,t)) and (theta x,t)) represent the vertical deflection of the structure and vertical component of the temperature gradient, respectively.

The finite element equations were as the equality constraints defined for the calculation of the internal forces and the deflections of the structure.

By evaluating the results obtained from FE simulation, the support conditions of the CL-girder, the thickness of the panels and the lower flange of the transverse beams were found to be the most relevant parameters affecting both the stress and the deflection distribution of the structure.

It is seen that the maximum deflection of the protected structure subjected to a certain explosive load varies with the two non-dimensional parameters of the foam cladding.

Unlike the air-backed condition, water-backed condition affects the damage and deflection of the sandwich structure in a different way because of the critical intensity of impulsive loads.

The mechanical behavior has been analyzed as both kinematic effect due to deflection of the composite structure and dynamic effect caused by the interaction between the impactor and the hydrodynamic and hydrostatic pressures over the loading.