Sentence examples for deflection corresponding to from inspiring English sources

This is supported by the measured values of deflection capacity (i.e., the deflection corresponding to the point of flexural strength) given in Table 6.

Comparison of maximum value of load and deflection corresponding to maximum load value for all the specimens is presented in Table 2.

Deflection corresponding to maximum load is 11.26, 49.46, and 33.63 % more for specimen PC-CRW, PC-CRS, and PC-BRS, respectively, as compared to monolithic connection.

The interfacial shear stress and the maximum deflection corresponding to the predicted values at maximum and service loads are also studied.

The downward deformation restoring capacity of UPSRC was superior to BPSRC and the residual deflection corresponding to service load (260 kN) were respectively −1.2 mm and −3.8 mm.

The effect on the deflection corresponding to the cracking and yield loads was not significant; however, the ultimate deflections were affected by prestressing.

Unlike the usual orthogonality relation for shallow beams in which the modal shapes are the shapes of deflections corresponding to the natural frequencies, the relation for the composite sandwich beams cannot stand without including the rotation angles.

The cracking load P cr and the mid-span deflection Δ corresponding to the cracking load of the specimens are given in Table 4.

Figure 15b shows the numerical deflection profile corresponding to the application of 24 N/mm, equal to the sum of the structural weight load and the maximum equivalent distributed load given by the jacks, depurated by the pre-camber.

The polygonal structure of the grains is apparent in the deflection image shown in Fig. 2c. Figure 2 Atomic force microscopy scan results for PSZT thin film deposited at 700 °C:a three-dimensional representation of film surface showing facetted tightly packed grains,b topography image obtained over an area of 1 × 1 μm2, andc the deflection image corresponding to the topography in (b).

The data were consistent with each other (see also Figure S7), except for a larger separation between the two dominant deflection states corresponding to the unfolded and folded states of the hairpin in the stiff linker data, which is an expected consequence of the inextensibility of the ten-helix bundle linkers.