Sentence examples for defect value from inspiring English sources

The competition analysis is carried out on the basics of fatigue strength to obtain the critical defect value.

Then the competitive giga-fatigue model for FV520B-I is established and the actual fatigue life is calculated by substituting the actual defect value into the corresponding fatigue life model.

The critical defect value is the direct criterion in practical engineering and the primary factor of final failure is determined by comparing the actual defect with the critical value.

Heterogeneity values (0 to 10,000) and perfusion defect values (93 to 40) were considered by physicians to cover the range of CBF observed in clinical practice.

These differences are within the error fluctuation range; therefore, the differences for the bulk and defect values seem to be reasonable.

Furthermore, one must account for the rounding involved in the calculation of mass defects: any Δm along a series leading to mass defect values above 0.5 consequently wrap them to Δm − 1, whereas values below −0.5 convert to Δm + 1.

Table 10 Process parameters with their ranges and values at three levels Parameter designation Process parameters Range Level 1 Level 2 Level 3 A Total alkalinity (g/l) 40 to 80 40 70 80 B Temperature (°C) 45 to 75456075 75 C Rinsing water (pH) 5.5 to 8.5 5.5 6.5 8.5 D Timing (min) 0 to 25 5 15 25 Table 11 Washing defect values and S/N ratio against trial numbers Trial no.

If both agents defect, the value w doesn't change, which means that agents didn't interact or that the interaction gets nullified N. In this game, the best action for any agent is to coordinate with its neighbor, either because it wins or because it doesn't lose.

In addition, depending on the type of defect, the value to a buyer may be less than the cost to the seller if the "fix" involves questions of taste.

Therefore, without the conclusive identification of the underlying causative genetic defect, the value of these reports for our basic understanding of muscle function and a comparative analysis with respect to the human diseases remains limited.

The change in percentage bone volume was calculated by dividing the difference in experimental and control defect BV/TV values by the control BV/TV value and then multiplying by 100.