Sentence examples for decreasing the sample from inspiring English sources

These studies not only stress the importance of studying infectious events but also, by decreasing the sample heterogeneity, allow to capture the environmental influence on genetic liability (Kazma et al. 2011).

The number of killer centers can be increased either by decreasing the sample temperature in the Mn implantation process, by decreasing the post-annealing temperature, or by an additional implantation process using Neon ions.

The results of a test similar to the previous one for the virtual instrumentation are shown in Fig. 19, while the difference relates to decreasing the sample time from 1 s to only 100 ms.

This finding suggests that decreasing the sample size and increasing the temperature have similar effects on the superelastic response of NiFeGa SMAs that had undergone two-stage transformation and indicates that a reduction in pillar diameter decreases the transformation temperature due to the difficulty of martensite nucleation on small scales.

After decreasing the sample temperature from 90°C to 40°C, DLS curves showed two new peaks: one peak was centered at approximately 0.65 nm and exhibited no significant change, but the other peak increased gradually from 59 to 190 nm during the cooling process (Figure 3b).

Strengths of response adaptive trial design include more efficient assessment of efficacy, limited risk of RCTs that find potential harm (by decreasing the sample size compared to frequentist statistical trial design), decreased time and expense (i.e., more efficient futility rules), improved drug dose selection and earlier completion of negative RCTs.

It was found that increasing the micro-cavity discharge source driving frequency and/or treatment time and decreasing the sample-array distance all led to a significant decrease in surface energy as determined by water contact angle measurements.

The semiglobal region of attraction is expanded by decreasing the sampling period.

For current CRNs, the CS has been used to alleviate the sampling bottleneck, which aims at decreasing the sampling rates for the acquisition of compressible signals[13, 14].

Though it does provide promising potential of dramatically decreasing the sampling rate via coprime pair, the estimation is inherently suffering the problem of taking much longer latency.

Naturally, the p values change as a consequence of the reduction in the number of data samples when decreasing the sampling rate from one sample every year to one sample every 4 years.