Sentence examples for decreasing the orientation from inspiring English sources

Then, the discrimination threshold of individual mice was determined by gradually decreasing the orientation difference of the rewarded and distractor grating until performance fell below 70%% accuracy.

Once 90%% accuracy was achieved, the test phase was started and the discrimination threshold of individual mice was determined by decreasing the orientation contrast of the two gratings until performance fell below 70%% accuracy.

Results indicated that compressive strengths of geopolymer mixes incorporating SF increases up to 7% substitution and then decreases up to 10% but still higher than the control mix, where 7% SF-digested calcium hydroxide (CH) crystals, decreased the orientation of CH crystals, reduced the crystal size of CH gathered at the interface, and improved the interface more effectively.

Reducing deflection at the rubber block end by decreasing the height and orientation angle was effective in securing the contact area between the rubber block and the mating surface.

The collagenase- and elastase-treated groups had the most significant effect on the mechanical properties among the orientation groups, decreasing the failure stress for both interlaminar and intralaminar groups.

This indicates that decreasing the fibers' in-plane orientation increased the figure of merit of media made of nanofibers.

It was also shown that when the diameter of the particles is comparable to that of the fibers, collection efficiency increases with decreasing the fibers' in-plane orientation, while the pressure drop remains almost unchanged.

The chondroitinase ABC-treated group only had a significant impact on the single layer orientations, decreasing the failure stress and strain (intralaminar group).

XRD analysis of the multilayers shows a combination of the orientations obtained for single layers with a progressive decrease of (2 0 0) orientation when decreasing the bilayer period.

The orientation increased with decreasing the diameter of fibers, leading to better thermal and electrical conductivity [17].

As mentioned above, cost(d) decreases as the orientation of d approaches the edge direction.