Although the taxol treatment did not completely rescue the mrh2-3 root hair waving phenotype, it dramatically decreased the waving angles of root hairs relative to the root hair growth axis, compared to the DMSO control (Figure 5B).
Similarly, the increase of the feedback delays decreases the wave speed.
When the CF content is higher than 0.2%, freezing thawing cycles can decrease the wave absorbing property of the composites.
Conversely, the porous-plate type exhibited adequate performance, with a larger plate porosity and moderately high mounting elevation tending to improve the uprush obstruction performance and further decrease the wave slamming loads.
In addition, assuming a constant wave velocity is no longer valid since water significantly decreases the wave speed.
In fact, Murai et al. [ 34] found that experimentally increasing the mass of the claw not only increases the waving cost, but also decreases the wave height, an important component of female choice.
In the premise of not reducing the accuracy of single wave identification, the method decreased the single wave parameters that required identification, and simplified the identification process.
EPA significantly increased serum IL-10 and EPA levels, the EPA/arachidonic acid (AA) ratio, and monocyte IL-10 expression and decreased the pulse wave velocity (PWV), an index of arterial stiffness, compared with the control group.
Replacing the linear term for average lag 0 20 mean temperature with a smooth term with maximum 4 df slightly decreased the cold wave effect, from 4.0%to3.2%2%, while using the original distributed lag term allowing both non-linear effects and flexibility in duration increased the cold wave estimate to 5.5%.
Increasing friction between the yarns decreases the longitudinal wave velocity whereas the transverse wave velocity is increased along with the increase of inter-yarn friction.
