Sentence examples for decreased pullout from inspiring English sources

Regarding the repair of such tears, Barber et al. demonstrated a decreased pullout strength of suture anchors in the anterior compared to the posterior part of the GT [ 7].

(3) The temperature has a minor influence on the maximum pull force, while the increased temperature greatly decreases the pullout energy.

(2) The chain length does not affect the two SWNTs' interaction force within a short separation distance, (3) The temperature has a minor influence on the maximum pull force, while the increased temperature greatly decreases the pullout energy.

4) The back-out of the screw by 360 degrees from full insertion did not decrease the pullout strength in any of the studied cases.

The results showed that a single ASF had a greater maximum applied load (Pmax) than a single HSF; however, at a mortar compressive strength of 30 42 MPa, its bond strength (τmax) and pullout energy (Ef) decreased by 40.9 55.8% and 16.9 79.7%, respectively, compared to those of a single HSF.

Once the fibre-matrix bond is fully detached, two plastic hinges of the fibre hook undergo cold work causing deformation and bending of the end hook (Alwan et al. 1999), in Fig. 12, the two plastic hinges are identified as 1 and 2. As a result of deformation and slippage of the first plastic hinge a sharp decrease in pullout load takes place.

The decrease in pullout strength of both the UPS-4 and UPS-3 screws was the same (13.3%).

Results: Previous drilling and tapping of pilot hole significantly decreased the insertion torque and the pullout strength.

The change in p from 2.0 to 3.0 mm decreased 9.0% and 12.2% of pullout strength for the UPS-4 and UPS-3 screw, respectively.

This fact indicates a decreased risk of pedicle screw breakage or pullout, even though the patient had Parkinson's disease.

However, for 3DH1 fibre with LE (15 mm) and 3DH2 fibre with LE (30 mm) a slight difference in pullout behaviour is observed when W/B ratio decreased from 0.25 to 0.20.