Sentence examples for decrease roughness from inspiring English sources
The triboreactions formed silicon and aluminum hydroxides which contributed to decrease roughness and shear stress at the contact interface.
In order to decrease roughness and protect CuNW TCEs against being oxidized, we fabricated CuNW/poly methyl methacrylate) (PMMA) hybrid TCEs (HTCEs) using PMMA solution.
In order to minimize the reduction in sp3 bond content over the decrease roughness and resistivity, DLC films were prepared by Si, B co-doping.
Lasers (e.g., KrF and XeCl excimer) have been used to decrease roughness via surface reflow in ridge waveguides; the laser selectively melts the sidewall edge, which flows under surface tension and solidifies into a smooth rounded layer [ 38, 39].
A recent study revealed that flax and borage supplements helped increase moisture and decrease roughness in skin.
It decreases with a decreasing roughness exponent H that leads to rougher interfaces at short roughness wavelengths.
The improved cycling stability owes to the decreased roughness of deposited TiO2 thin film with the increase of lifting speed, as illustrated in Fig. 4a.
Because of a decreased roughness in these holes which become visible by the frequency shift image (Figure 3), we expect to see the plain substrate within the holes.
Finally, as a result of the etching, due to the thinner catalyst and significantly decreased roughness, the growth of thin SWNTs with a higher growth rate was achieved [19], which was also observed in Fig. 3 A(I II).
The roughness obtained for both concentrations is displayed in Figure 8: the results from the nanoconstructions prepared with 10-3 M remark the decreasing roughness as the film increases, whereas the 10-4 M films show a monotonically increasing growth, confirming the surprising results reported by Decher et al.[23].[23]
This suggests that improvement of cell attachment and proliferation may be mediated by differences in the amount of wettability (decreased water contact angle) after exposure of scaffold to culture medium for long term which, in turn, causes more protein adsorption in the surface of silk fibroin scaffold (decreased roughness).
