Sentence examples for decrease of coating from inspiring English sources

Eventual decrease of coating porosity is analyzed.

The decrease of coating hardness by increasing SOD can be associated with increase in the size of grains inside the lamellae and also voids.

The decrease of coating thickness results in lowering of strain accumulation and hence decrease of TiN (111) texture coefficient, and corresponding increase of TiN (220) texture coefficient is observed (Figure 8a) on bare AISI M2 substrate.

The decrease of coating hardness could decrease constraint stress, and hence decrease the shear stress at the interface, which resulted in higher critical load.

The application of cathodic protection at more negative potentials than − 750 mV affected the performance of the both coatings causing the decreasing of coating resistance (Rcoat).

With increasing tilting angle the holes were closed during the deposition of the thermal barrier coating with decreasing of coating thickness.

The continuous decrease of R coating for SC was caused by electrolyte uptake.

The decrease of the coating effective properties caused by the presence of porosities and microcracks was investigated by measurement and calculation works.

According to this figure, the transmittance of the ITO thin films increased with decrease of the coating number until 3 times, reached the maximum transmittance of more than 90%% and then decreased to lower degrees with addition of the coating number.

This usually causes a decreasing tendency of coating porosity with increasing spray distance.

3 5 rounds of panning with decreasing concentrations of coating peptide in each round were usually required to isolate strong antigen binders.