Sentence examples for decrease in the storage from inspiring English sources

The typical features of the Payne effect, i.e., a decrease in the storage modulus with increasing strain, can be seen for all the studied composite samples.

Despite better performance in tensile strength, the recycled sample showed an intense decrease in the storage modulus in temperatures above 30 °C.

The addition of less than 1 vol%, 33 nm zinc oxide nanoparticles into a polyurethane matrix resulted in approximately 40% decrease in the Young's modulus, 80% decrease in strain at fracture, and 50% decrease in the storage modulus, but at the same time resulted in an ∼11 °C increase in the glass transition temperature of the polymer.

These composites are less rigid materials when compared to BC, which is confirmed by a decrease in the storage tensile modulus, and present good swelling ratios (~200 260%).

The results showed decreases in the storage modulus and the loss modulus of the asphalt binders at low temperature when the graphite content was less than 30%.

However, the additional Mg loading to the support (Mg/Al ≥ 5 5) gave rise to the drastic decrease in the NOx storage activity and the poor thermal stability.

Lowering the Pt loading in the Pt BaO/Al2O3 catalyst from 1.0 to 0.5 wt% resulted in a 15% decrease in the NOx storage capacity (NSC) under the lean condition but the N2 selectivity under the rich condition declined dramatically (from 85%to5353%), indicating that the NOx reduction performance under the rich condition is the key to low platinum NSR catalysts.

showed the two-phase character: two-step decrease in the dynamic storage modulus E′ versus temperature curve and two peaks in the dynamic loss tan δ versus temperature curve, indicating phase separation via reaction-induced spinodal decomposition (which was confirmed by scanning electron microscopic observation).

Incorporation of the peptide RGDS at a concentration of 300 μM in a PEG hydrogel (10% w/v) led to an ∼20% decrease in the hydrogel storage modulus (G′), and accordingly, the calculated average network mesh size increased by ∼1 nm.

Overall, the publications W1315 and L2013 both recognise the decrease in water storage in the Canadian prairies from 2002 to 2004, as well as the recovery from a drought that started in 2004 and the floods that begin in 2010 due to heavy summer rainfall.

Comparing to the single-phase molten salt heat storage, the two hybrid thermocline heat storage manners with porous fillers lead to a certain decrease in the effective heat storage capacity.