Sentence examples for decrease in the instability from inspiring English sources

Stresses generated by externally applied loads, on the other hand, always lead to a decrease in the instability wavelength compared with the Rayleigh instability wavelength.

Studies were also included if they had a follow-up of 1 year or more as Robinson et al 11 have shown a decrease in the incidence of shoulder instability events after 12 months.

The use of nanofluids in thermosyphon loops has shown an increase in the efficiency, a decrease in flow instabilities, and an increase in the flow rates.

Peter and Flock equation was used to draw a relation between oil recovery and finger characteristics, where the increase in capillary numbers leads to a decrease in both instability scaling index and incremental oil recovery.

Open image in new window Figure 8 Effect of effect-yarn overfeed on core yarn tension (T 1 ) and textured yarn tension (T 2 ). Figure 9 illustrates that there is a slight decrease in loop instability with increasing effect-yarn overfeeds in both air-jet and steam-jet texturing.

The decrease in the absorbance was probably attributed to the instability of the PG derivatives at higher temperatures.

This indicates a significant decrease in the patients' pain and knee instabilities during activity as well as a significant increase in patients' quality of life.

This indicates a significant decrease in the patient's pain and knee instabilities during activity.

The dashed curve is obtained without considering of stresses accumulated in the nanodevice, the solid one is obtained taking into account the work performed by these stresses, after the contact bond instability; therefore, steep decrease in the lifetime of nanodevice at transition from the dashed curve to the solid one is a quantitative measure of considered phenomenon of the synergism.

After this first aggregation, the instability caused by brightness could induce the progressive decrease in the number of woodlice in the small aggregates.

With further increase in temperature, inhibition efficiency decreases which indicate the instability of the adsorbed film above 50 °C.