The phrase "decrease factor" is correct and is commonly used in written English.
It can be used when referring to something that needs to be decreased, such as a variable in a mathematical equation, a risk, or any other measure that requires a decrease in amount. For example: "The implementation of this new safety measure will undoubtedly decrease the risk factor."
At all three points in time, Factor I correlated significantly with anxiety decrease, Factor II with increase and Factor III did not correlate with anxiety at all.
The range analysis based on orthogonal design is adopted to determine the sensitivity of system parameters to the net power output of ORC system, thermal efficiency, the SP factor of radial inflow turbine, the power decrease factor of the pump and the total heat transfer capacity.
The order of factors sensitivity on performance indices of the net power output of the ORC system, the thermal efficiency, the size parameter of radial inflow turbine, the power decrease factor of the pump and the total heat transfer capacity are determined by the range obtained from the orthogonal design.
The results show that the geothermal temperature influences the range of the factors to the net power output, SP factor of radial inflow turbine, and the total heat transfer capacity, but it has no effect for the range of the factors for the thermal efficiency and the power decrease factor of the pump.
The step-size increment t ′ and the decrease factor α .
However, the ANFIS model could only be generated by tuning several training options, such as raddi, initial Mu, Mu increase factor, and Mu decrease factor, which was a time-consuming stage.
Due to the combined actions of increasing factor and decreasing factor, the reaction degree of slag in ternary blended paste is similar with that of binary blended paste.
As a result, the density and mass flux of the solar wind becomes much smaller than the decreasing factor of the input energy.
Therefore, h 1 is set to be (h_{1}=text {max}left {frac {1}{f_{text {max}}},alpha hright }), where α is a decreasing factor and 0<α≤1.
When compared with LMP, STA decreased factor VIIc, which is consistent with the literature.
Another reason for the bigger flexion gap, compared with the extension gap, involves pre-operative flexion contracture, which was generally considered a decreasing factor of extension gaps.
