Sentence examples for decoding the data from from inspiring English sources
DNF addresses this problem by not decoding the data from the two users.
The data from the current user is decoded after decoding the data from the previous users whose signals have been subtracted from the received signal.
In particular, we looked for correspondence in the voxel weights across pair-wise comparisons within single subjects as a potential explanation for why the spatial activity patterns in certain areas might show across-effector decoding (the data from two representative subjects is shown in Figure 4 figure supplement 2; see also Formisano et al., 2008 for a similar approach).
The Sink receive data and decode the data from network coder nodes.
After deciphering, the eavesdropper must decode the data from a deteriorated signal.
In DF, the relay fully decodes the data from the source node and then delivers it after re-encoding the data.
The relays are DF relays, in which case a relay fully decodes the data from the base station before forwarding to the users.
The surface part, which receives and decodes the data from the down-hole, includes a mud pressure sensor, an interface box, computers, and displays for drilling operators or technicians.
SCP: a transmission strategy where the BSs can only decode the data from their local users, i.e., intra-cell users and consider the inter-cell interference from the inter-cell users as a Gaussian noise (uplink); while the BSs can transmit information only for their local users, i.e., intra-cell users (downlink).
SCP: a transmission strategy where the BSs can only decode the data from their local users, i.e., intra-cell users and consider the inter-cell interference from the inter-cell users as a Gaussian noise (uplink); while the BSs can transmit information only for their local users, i.e., intra-cell users (downlink). .
As illustrated in the bottom of Figure 3, spectrum sensing is performed at SU Rx (receiver), which firstly decodes the data transmitted from SU Tx (transmitter) treating the PU's signal as interference, and then utilizes the remainder of the decoded signal to detect PU's signal.
