Sentence examples for cylinders rotation from inspiring English sources

Feedback control is considered by acquiring the hot-wire sensor signal in the wake and using it for the cylinders rotation speeds update.

In that configuration, it is also possible to optimize further the architecture by using a smaller spacing for the flow passage in which the flow is in the direction of the cylinders rotation, and larger spacing for the flow passage in which the cylinders oppose the main stream.

Variables studied were: cylinder rotation speed, physical properties of the solution and cylinder equivalent diameter.

The control parameters are the amplitude and the frequency of the time-harmonic cylinder rotation.

The effect of cylinder rotation on these transitions is also quantified, with forward (prograde) rotation enhancing three-dimensional instability and reverse (retrograde) rotation stabilising the wake.

The wake characteristics and the wake transitions are shown to change dramatically under the influence of cylinder rotation and wall proximity.

At inner cylinder rotation rates ReRec > 5.0, the model recovered the commonly used discrete approximation of the one-dimensional diffusion equation.

The new burner allows for turbulence generation by cylinder rotation at constant cylinder radii ratio and for convective stabilization of stationary flames at a fixed location in the burner, for long-time flame diagnostics.

The spraying air pressure, the cylinder rotation speed, and the cylinder spray nozzle distance were tailored in such a manner that the roughness of the obtained free films was similar to that from reference coated particles.

The effects of catalyst loading (0 8 g/L), inner cylinder rotation speed (0 50 rpm), annular gap-width (7.5, 17.5 and 32.5 mm), initial pollutant concentration (10 50 mg/L) and mode of illumination (continuous or periodic) were studied.

Open image in new window Figure 3 Structure of the polishing equipment Table 1 Major parameters of the polishing equipment Cylinder diameter D (mm) Cylinder height H (mm) Workpiece, headstock distance R (mm) Cylinder rotation speed N (r/min) Workpiece speed n (r/min) Workpiece up and down speed P (mm/min) 800 450 150 0 20 0 30 0 10.