Sentence examples for cycles indicating that from inspiring English sources
Even cycled at high current density of 500 mA g−1, Li1.95Mg0.05Na2Ti6O14 still provides the specific capacity of 167.4 mA g−1 after 100 cycles, indicating that low dose of Mg2+ doping can effectively improve the lithium storage capability of Li2Na2Ti6O14.
Although our Al-Sb-C composite had low initial coulombic efficiency (∼59%), recovery to ∼ 97% occurred within three cycles, indicating that initial side reactions are quickly reduced over the course of cycling.
The first migraine attack occured on days 1 5 (each 12 20% of cycles), indicating that prevention has to start earlier than the expected withdawal bleeding (Fig. 1).
As observed, the MO degradation ratio has no significant difference after 3 cycles, indicating that the as-prepared Ag/Cu2O composites exhibit good durability as photocatalysts for photodegradation of MO in aqueous solution.
Instead, in our case, given the large developed surface of PSi, the diazonium reduction peak is still visible after five cycles indicating that the density of grafted molecules is not high enough in the first cycle.
It can be seen clearly that the absorption edge sinks after annealing, especially for samples of 300, 400, and 500 cycles, indicating that the annealing process is very effective [31].
The galvanostatic cycling originating from over 330 charge discharge cycles indicated that encapsulation of Ni3Sn4, FeSn2, and Cr2Sn3 into ACNTs results in surprisingly excellent cycling performance, high rate capability, and increased initial coulombic efficiency (81.4%).
Multiple adsorption and regeneration cycles indicate that there is little or no loss in adsorbent capacity on regeneration.
The profiles of the VFAs concentration and the high level of methane production during the successive cycles indicate that acetogenic and methanogenic reactions proceeded fairly well.
Thereafter, the impedance test after 100 cycles indicates that pristine Si shows a larger charge transfer resistance as shown in Fig. 6b.
The test results for freezing and thawing within 200 cycles indicated that the freeze thaw cycles had a slight effect on the tensile response of the SHCCs.
