Sentence examples for cutting decreased from inspiring English sources

We found that winter cutting decreased habitat diversity and structural heterogeneity at multiple scales.

Another partial explanation for the difference between young and mature stands is that the basal area of the young stands would increase too much without cutting, decreasing the relative value increment of the stand (see Figure 5).

This is for the reason that with rise in cutting speed, the frictional energy and shear plane energy are optimal (Chinchanikar & Choudhury 2015a) followed by culminated temperature at the shear plane and machined workpiece surface (see, Fig. 3), along with enhances the thermal softening of workpiece material and hence, forces needed for cutting decreases that causes an improved surface finish.

When this distance is 2.0mwith airduct in the air return side, it has the best dedusting efficiency; in which the dust concentration in the front of roadway after 60 s of digging and cutting decreases from 1150 mg/m3 to 365 mg/m3; the average dust concentration in roadway decreases from 597 mg/m3 to 144 mg/m3; and the total dedusting efficiency reaches up to 75.88%.

Similarly, the expression of miR172 in mature cuttings and that of EgAPETALA2 in juvenile cuttings decreased after 1 day and remained low until day 9.

Interestingly, miR156 expression was not affected during the first 9 days of induction, whereas that of EgSPL5 in mature cuttings decreased after 1 day and remained low.

The mechanism of edge chipping reduction at the hole exit is that cutting force decreased as the undrilled thickness decreased.

Specific cutting energies decreased with increasing rake angle, increasing depth of cut and increasing cutting speed.

Increasing the frequency and cutting speed decreased the kerf width and the roughness of cut surface, while increasing the power and gas pressure increased the kerf width and roughness.

It is found that as the cutting depth decreases, both the tangential and normal cutting forces decreases; however, the tangential cutting force decreases faster than the normal cutting force.

Tmax and cutting time decreased with CaCl2 addition.