Sentence examples for cut width from inspiring English sources

The works reveal the effects of various parameters, such as cutting speed, depth of cut, width of cut, crystal orientation, and rake angle, on chip formation and cutting force development.

Imaging of stained brain slices was used to characterize cut width and maximum cutting depth.Cut width decreased exponentially as a function of depth and increased as the cube root of laser energy, but showed about 50% variation at fixed depth and laser energy.

The experimental results showed the material swelling/recovery on the machined surface was significantly reduced in presence of magnetic field in comparison to that of diamond cutting without a magnetic assistance; the accuracy of depth of cut, width and radius of cutting groove in a magnetic field reached satisfactorily over 98%.

For example, at a laser energy of 13 µJ, cut width decreased from 158±± 43.1 µm (mean ± standard deviation) to 56 ± 33 µm over depths of approximately 200-800 µm, respectively.

We describe an optical technique to make sub-surface incisions in in vivo rodent brain and characterize the relationship between the cut width and maximum depth of these optical transections as a function of laser energy.To produce cuts, high intensity, femtosecond laser pulses were tightly focused into and translated within the cortex, through a craniotomy, in anesthetized rodents.

In addition, the higher tension decreases the wire vibration amplitude and hence decreases the cut width so that the speed is higher for the same discharge energy.

The design variables comprise headline length, steepness of trawl side cut, width-to-depth mesh ratio of the trawl mouth (gape), vertical wing-end mesh count, and netting solidity; all of which effectively determine the planar twine-area of the trawl.

Cut width-wise strips of orange construction paper, each with a width of roughly 1 inch (2.5 cm).

These are blades which can actually be adjusted to cut different width kerfs (the width of the material removed in the blade path).

Preliminary results suggest that knives type can be predicted from cut mark width, and that knife edge thickness correlates with cut mark width.

Place each strip on a cutting mat and cut random widths, from five to 12cm.