Sentence examples for cut section from inspiring English sources
"cut section" is a correct and usable phrase in written English
It refers to a portion of something that has been removed or separated from the rest of it, often for visual or analytical purposes. Example: In the report, we included a cut section of the graph to show the change in sales over the past year.
The objective of this work is to do parametric analysis of process parameters for fiber laser cutting system on surface characteristics of the cut section in the cutting of 3 mm Stainless Steel (SS) sheet (ASTM 304).
The objective of this work is to do parametric analysis of process parameters of CO2 laser cutting system on surface characteristics of the cut section in the cutting of 5 mm Stainless Steel (SS) sheet (ASTM 304).
Don't let the cut section of ceiling fall to the floor after cutting, as it could pull additional pieces of drywall or plaster with it.
The aim of this work is to relate the cutting edge quality parameters namely: upper kerf, lower kerf, the ratio between them, cut section roughness and operating cost to the process parameters mentioned above.
Wind tunnel simulations of the study site with and without the cut section present indicated that the cut section reduced the concentrations of primary emitted vehicle pollutants by 15 25 percent for receptors located approximately 20 m from the highway.
The cut section actually provides both rotational and axial ductility/deformability to the connection, enhancing its fire resistance.
The rectangular IMCHS is designed with length and width of 10 mm and 0.057 mm respectively while optimum cut section number, nc = 3.
The at-grade locations also experienced a higher impact from primary vehicle emissions than those measurements made at similar distances along a cut section.
This study used a non-destructive method employing virtual cut section (imaging technique) to analyze the air void properties of laboratory-fabricated porous asphalt.
The coupled mass and momentum equations are solved for the steady-state solutions of the pressure and velocity distributions at a cut section of a tumor.
Laser cutting of medium density fibreboard (MDF) is a complicated process and the selection of the process parameters combinations is essential to get the highest quality cut section.
