Sentence examples for cut depth from inspiring English sources

The effect of cutting parameters on microstructure is assessed by varying the cutting speed and cut depth, while keeping the feed rate constant.

The near surface deformation angle and deformation depth was found to be a function of cutting speed and cut depth.

In actual nano-cutting process, because of the vibration of the ultra-precision machine tools and the cutting tool, the cut depth changes constantly.

In this paper, a novel elliptical vibration assisted OOS was designed to achieve a low cutting force under the condition of deepening cut depth and reducing cutting speed, based on the analysis of brittle fractures of the bone and elliptical vibration assisted cutting kinematics.

A preliminary experiment to determine the optimal turning process parameters indicated spindle speed, feed rate, and cut depth clearly affect cutting performance.

Fig. 4 The subsurface defect distribution and the depth of the SSD layers with different cut distances Fig. 5 The variation of depth of the SSD layers with the cutting distance at a certain cut depth.

Different cut angles and cut depths of barbs were prepared and tested in vitro for their tensile and tissue anchoring properties by means of a novel suture/tissue pullout test.

Consequently, we measured the forces to push narrow (2.5-cm wide) square and round rods through a control material, Ottawa sand, and JSC-1A lunar mare regolith simulant at different cut depths in a controlled laboratory setting.

Table 1 Milling machine working conditions Rotate speed (r/min) Feed speed (mm/min) Cutting depth of Y direction (mm) Cutting depth of Z direction (mm) Sample frequency (kHz) 10400 1555 0.125 0.2 50 Open image in new window Figure 5 Wear processes of milling tools (a) C1, (b) C4, (c) C6.

However, flank wear is affected by the cutting speed and interaction of feed-depth of cut, although depth of cut has not been found statistical significant, but the flank wear is an increasing function of depth of cut.

Cutting speed, depth of cut and feed were selected as machining parameters of turning operations.