Sentence examples for curves of material from inspiring English sources

Stage 7: As shown in Figure 3b, c, applying weights in stages 5 and 6 makes the new reflectance curves of material and pixels to look similar.

Besides, this information is also important in selecting a pipe material or material for connections suitable to withstand fatigue failure, by reference to the S N curves of materials.

The most important factor contributing to the accuracy of modelling is the plastic curve of material, for that reason the experimental investigations (compression testing on specimens Ø20mm×20 mm) were performed and results in form of Hollomon Ludwik's power law were obtained.

In this paper, the simulation study is carried out with the contact finite element method, using the stress strain curves of rubber material tests, Mooney-Rivlin constitutive model material parameters are determined through data fitting.

Finite element simulations of spherical indentations accounting for frictional contact provide validated load indentation output for assessing and improving existing methods used to determine the stress strain curve of materials with significant pile-up.

Stage 6: at this stage, a new weight for each material according to the area confined between curves of reference material and target pixels calculated in stage 5 was defined using the following equation: w a ( i ) = ∣ A r ( i ) - A t ∣ - 1 ∑ j = 1 N S ∣ A r ( j ) - A t ∣ - 1 (9).

The testing results obtained in the current study together with available testing data in the literature are summarized and used to formulate the dynamic stress strain curves of ionoplast material at various strain rates, which can be used in analysis and design of structures with ionoplast material subjected to blast and impact loads.

The recorded stress strain curves of the material indicated that EPS foamed concrete is ductile.

The purpose of the implicit model is to modify the stationary stress strain curves of the material.

Polarized absorption and emission spectra as well as luminescence decay curves of this material were recorded as a function of temperature in the 5 300 K temperature region.

In case the condition is not met, then CR curves of both material and pixels will be used in the next stages.