The phrase "crystallization point" is correct and usable in written English.
It can be used in scientific contexts, particularly in chemistry, to refer to the temperature at which a substance begins to crystallize.
Example: "The crystallization point of the compound was determined to be 150 degrees Celsius."
Alternatives: "freezing point" or "solidification point."
It should be noted that all these crystals were grown slowly at temperatures just below the THF hydrate crystallization point.
RUSSIA: Big Echo FPRF – Crystallization Point Novosibirsk-based shoegaze band FPRF prepares for its next full-length release with Crystallization Point, a calm and beautiful slow-burning jam backed with remixes by beats producer Ta-ku and future garage from Nocow.
Firstly, water crystallization point can be depressed to about −17 °C on prepared super-wetting surfaces which is 3° lower than that on hydrophilic glass surface.
The PEEK exhibits the biggest friction coefficient, but the smallest wear rate at a temperature slightly higher than the PEEK crystallization point.
When T a approached, or even higher than, the primary crystallization point (i.e., 725 K), the crystallization occurred and the IMCs such as Fe3Si, Fe15B2Si3, and Fe2B formed.
With the increase in T a, the volume of the Fe78B13Si9 ribbons underwent an appreciable change, which first expanded as T a approached the primary crystallization point and then decreased rapidly after crystallization, as clearly observed during the annealing treatment.
These opposite trends within the two alloy systems arise mainly from differences in the Al dendrite coherency and first intermetallic crystallization points, and in the crystallization behavior of β-AlFeSi phase.
Early mall developer Victor Gruen called them "crystallization points for suburbia's community life". But these days, the rise of online shopping and a lingering economic crisis have sucked away malls' reverie.
From the viewpoint of wettability, the amorphous Fe78B13Si9 substrate can be joined by lead-free Sn-base solders at a temperature much lower than the pre-crystallization point. .
From the viewpoint of wettability, the amorphous Fe78B13Si9 substrate can be joined by lead-free Sn-base solders at a temperature much lower than the pre-crystallization point.
To favour crystallization, three point mutations (K715D, R886S and R900D) were introduced on the surface of the dSfmbt-4MBT construct; these mutations do not significantly affect H4K20me1 binding (Table II, Materials and Methods).
