Sentence examples for corrosion length from inspiring English sources

This evaluation focuses on three interrelated issues: (1) corrosion mechanism, (2) the accuracy of the maximum allowable corrosion length, which is the safe maximum pressure level, and (3) practical problems excluded in the B31G criteria.

The detailed analytical model was employed to investigate the effects of corrosion degree, length of corroded zone, and span to depth ratio on flexural strength.

It was observed that the most important parameter governing the nonlinear cyclic response is the distribution of localised pitting corrosion along the length of the corroded bars.

This paper describes an experimental investigation into the effect of corrosion damaged partial length in one shear span on the shear behaviour and load capacity of reinforced concrete (RC) beams, where 14 RC beams were tested in four-point bending.

Test results of the RC specimens were compared with theoretical results of the corresponding noncorroded bond-perfect RC beams, and the differences were analyzed to deduce the influence of the bond and corrosion within partial length on behaviour and load capacity of RC beams.

The two girders had uniform corrosion along their length and this corrosion mostly concentrated within the tension flange and the webs of the girders were not severely corroded.

Inspection results from the last five years revealed systemic and extensive corrosion throughout the length of the pipeline.

Brown et al. (1995) found a correlation between corrosion and the length of neck extensions.

However, current documents provide limited guidance on the incorporation of deterioration aspects such as corrosion, insufficient anchorage lengths, and crack formation.

A local corrosion of a shorter length of tensile bars decreased beam strength and ductility more greatly than an extensive corrosion of a longer length of bars.

In assessing the residual life span and reliability of the in-service RC structures, it is very important to consider the severe corrosion damage within certain length of the RC elements.