Sentence examples for corresponding to the equivalent from inspiring English sources

To determine effective damping and stiffness coefficients corresponding to the equivalent linear system a statistical linearization scheme was used.

Also, by adjusting the split ratios it was possible to reduce the two-phase pressure drops in cyclic operation below the levels corresponding to the equivalent barycentric constant-throughput operation.

In the scenario where a node was inserted in the test PTM (refer Step 2b: Case 2, Algorithm 1) the (I_{test}) partition will include the same peak sub-region corresponding to the equivalent peak region of (eta _{ref}), the reference PTM node.

As shown in the structure alignment in Fig. 3, of the three residues present in CBMCex, W17, W54 and W72, only the first two, corresponding to the equivalent W249 and W286, are present in the CelStrep CBM while the third one is replaced by an aspartic acid residue (D304).

The parameters of the lognormal fragility functions (median values in g and corresponding standard deviations) are shown in Fig. 6 in terms of peak ground accelerations (FRACAS results), and in Fig. 7 in terms of spectral accelerations corresponding to the equivalent single-degree-of-freedom (SPO2FRAG results).

It is important to point out that there is a significant difference between the number of Ga atoms initially supplied, corresponding to the equivalent amount of 10 MLs, and the number of Ga atoms, evaluated to be equivalent to around 3 4 MLs, inside the final structure.

In these energy scenarios, if the amount of coal displaced is greater than the lower of the equivalents of coal determined, this would result in a deficit in the supply of that utility corresponding to the lower equivalent.

Non-equilibrium molecular dynamics (NEMD) simulations are performed assuming flow conditions corresponding to the macroscopic equivalent of planar Poiseuille flow.

The cM locations entered in the file are slightly different from those in the second-generation linkage map [ 22], having been scaled to correspond to the full-coverage map lengths shown in Table 1 by adding an offset value to each marker location corresponding to the cM equivalent of the p-telomeric end of the chromosome not covered by the second-generation linkage map.

MCF-7 and T47D monolayer cultures, stably expressing ZsGreen-cODC protein were treated with daily fractions of 3 Gy for a total dose of 0, 3, 6, 9, 12, or 15 Gy or a single dose of 8.5 Gy, corresponding to the biological equivalent for 5 × 3 Gy, and the percentage of ZsGreen-cODC+ CICs was analyzed 48 hours after the last dose.

The time-equivalent seismic attribute represents the geometric, kinematics, dynamic, and statistical features of seismic waves corresponding to the time-equivalent seismic unit.