Sentence examples for corresponding strains and from inspiring English sources

The easiest and the most accurate way to evaluate stresses in such specimens is to measure the corresponding strains, and by knowing the modulus of elasticity of used material, stresses can be evaluated.

The corresponding strains and confirmed sources of importation are shown in the Appendix Figure 2. All 53 member states of the WHO European Region except 1 have implemented a routine vaccination program against measles, resulting in an overall regional coverage of 94% for the first dose of measles-containing vaccine.

Sudo et al. (1993) concluded that reduction in spiral pitch outcome in increases in strength and the corresponding strain, and improved the descending branch of the stress strain correlation of confined concrete.

The comparison between test results and predictions, by the means of the confined compressive strength with corresponding strain and the total stress strain curve, shows that the proposed approach yields a reasonable level of accuracy.

Groups of mice were challenged with a lethal dose of the corresponding strain and 1 h later antibiotic treatment was initiated, with administration at 8 h intervals for a total of 6 doses.

Loss of these genes is expected to be disadvantageous to each corresponding strain, and may explain the differences in the ecology of several phage types.

The equation consisted of the applied loads P 1 and P 2 corresponding to 50 and 25% of the ultimate load, respectively, and the corresponding strains ε1 and ε2.

The critical bending moment is defined as the maximum moment at the critical point of bending vs. compressive strain curve, while the corresponding stress and strain are critical compressive stress and critical compressive strain.

text{for high-strength steel} (4 where ( f_{s} ) and ( varepsilon_{s} ) = steel stress and corresponding strain; ( f_{ys} ) and ( f_{us} ) = yield and ultimate stresses; ( varepsilon_{ys} ) and ( varepsilon_{us} ) = yield and ultimate strains; and ( E_{s} ) = elastic modulus.

Despite the difference in CIN rate obtained for corresponding strains between qCTF and ALF assays, the CIN rate change for mad1 Δ mutant compared with WT as measured with these assays agreed well.

The model was used, in combination with measured joint kinematics and published EMG recordings, to estimate the forces and corresponding strains in the ITB during running.