Sentence examples for corresponding heights from inspiring English sources

If we allow a,b,c to be the sides of the triangle and x,y,z to be the corresponding heights, we get: a*x = 2A b*y = 2A c*z = 2A We then set x,y, and z to be 1, 2, and 3. a = 2A b = A c = 2A/3 The triangle inequality states that a 2A < A + 2A/3.

Pearson correlation coefficients were used to correlate the change in pelvic obliquity with the corresponding heights of heel lifts; for the [frac14]-in heel lift, they were.67,.88, and.71, and for [frac12]-in heel lift they were.73,.79, and.87 for the intersulcate, interalar, and sacral surface lines, respectively (all P[lt ].001).

As the resulting 3D models provide a description of the shape of intervertebral disc spaces in a complete parametric form, morphometric analysis was straightforwardly enabled and allowed the computation of the corresponding heights, widths and volumes, as well as of other geometric features that in detail describe the shape of intervertebral disc spaces.

The corresponding heights of the Si NWs are about 0.54, 2.03, 3.35 and 4.59 μm, respectively.

The measured hydrodynamic pressures during the earthquakes were calculated by deducting the initial hydrostatic pressure from the total water pressure recorded by the sensors at the corresponding heights.

We use the value of the aluminum contents, ( x Al 1, x Al 2 ), in the confining barriers to monitor their corresponding heights.

The δ15N values are indicated on the chromatograms with the corresponding peak heights (mV) shown in parentheses.

The corresponding height criterion used in the analysis of CBH I was 4.0 nm.

This data set is characterized by effective baselines ranging from 182 to 75 m with a corresponding height of ambiguity of 38 113 m (details: Supplementary Table 2).

In these clouds, the researchers found, precipitation could begin only at a height of about three miles above the base of the cloud, while in "clean" clouds the corresponding height was about a mile.

In the corresponding height profile in Fig. 2d, we observe a minimum in the topography at the position of the dotted line, while the QL step can be identified by its height of ∼1 nm.