Each sample was processed as described above, and the parameters extracted from the two-component fits are shown in Fig. 4. The fraction bound, f b, is the fraction of the correlation curve which represents a slow component (bound antibody) and is expected to correlate with the concentration of vWF in the sample.
The average correlation curve showed minimum correlation at time lags of around 0 2 seconds (Fig. 6a).
Finally, 432 correlation curves were obtained and all of them were above the linear correlation curve.
Since the area under the cross correlation curve is related to spike count correlation, we aimed at elucidating plausible excitatory and inhibitory interactions among neurons categorized to different CRPs by separating positive from negative noise correlations (Fig. 6c), respectively28,42.
Thus, the stationary tangent, at t=t0, to a smooth correlation, curve or process, is the one with the same curvatures at t0 (but constant).
Due to its simplicity, the linear correlation curve was proposed to calculate the bearing capacity of aluminum alloy members under eccentric compression at temperatures under 300 ℃.
The resulting correlation curve for each test is obtained by changing the level of compaction, water/cement ratio and concrete age of specimens.
Permeability reduction, adsorption reversibility, inaccessible pore volume and selection of a correlation curve for the function of viscosity vs. concentration can influence NPV by less than 3%.
The results revealed that the proposed correlation curve is safe and economical, while the design method suggested in EC9 is more conservative, which can be used as re-checking for important structures.
As expected, a high degree of cross-correlation was observed (Figure 2A, 2B), as demonstrated by the high amplitude of the cross-correlation curve relative to the autocorrelation curves of the individual channels.
Ncc is the inverse amplitude of the cross-correlation curve, and the cross-talk between channels, Q, was estimated to be approximately 5% for the GFP and mCherry probes using the filter sets described above.
