Sentence examples for converter failure from inspiring English sources

At 6.0 s, WFVSC1 is disconnected from the MTDC network owing to converter failure.

By a switchable line connecting double layer capacitor and auxiliaries high redundancy in case of battery or converter failure is achieved.

Another interpretation of changing the summation with picking the one with the largest absolute value would be that if impulses are present, they replace the original samples as it would in fact be in the case of A/D converter failures.

This paper investigates the control and protection strategy against a converter-side AC fault during the blocking failure of the converter of a four-terminal MMC HVDC system.

It intends to provide a wide spectrum on converter operating stress, component failure modes, algorithm performance requirements, FDs for different converter topologies, and challenges in designing FDs.

A TPGS or WPGS (wind power generation system) includes a power electronic converter in which the failure rates of electronic components are sensitive to their junction temperatures, whereas the junction temperatures depend on delivered powers of a TPGS or WPGS.

The condition discussed in this section is that one of the six converter arms has blocking failure, i.e., all the SMs on one arm fail to be blocked, while the other five arms are blocked normally.

The presented fault tolerant topology allows a "five-leg" structure with converters reconfiguration after switch failure detection.

Reliability analysis of frequency converters based on failures and outages reports constitute an important basis for asset performance and management.

In comparison with the complete blocking failure of one converter arm, the possibility of having the blocking failure on part of a converter arm would be higher in practical operations.

Three major components of the system, i.e. wind turbine generators, photovoltaic arrays, and DC/AC converter, may be subject to failure.