Sentence examples for conventional m from inspiring English sources

In contrast, the M H curve of SH03-07 islightlyly irreversible and the ratio that corresponds to the conventional M rs/M s is 0.06.

The conventional M robust estimator (RRLSS) may converge very slowly, due to the introduction of the non-linearity first derivate, ψ′, and the unit FF in the recursive generation of the weighted matrix (Eq. 18).

However, the proposed adaptive M robust algorithm with combined scale and forgetting factors has much better parameter tracking performance than the conventional M robust algorithm with only scale factor.

The stresses in the test specimen peaked at only about 32 MPa and had the conventional "M" profile with tensile stress peaks in the heat-affected zone outside the weld.

Moreover, the standard least-squares algorithm with variable forgetting factor is very sensitive to outliers, while the new adaptive robust method with combined scale and variable forgetting factor, and the conventional M robust-based method, with scale factor, are rather insensitive to such a disturbance.

In order to mitigate the high rate of unreliable measurements in obese patients, a lower frequency (2.5 MHz) XL probe has been developed that has achieved reliable measurements in 61 % of obese patients in whom measurements were unreliable using the conventional M probe [77].

The sniper's choice of the XM15 was a little unusual, Mr. Faraday said, because it has a 16-inch barrel and is therefore less accurate than the conventional M-16, which has a 20-inch barrel, or many sniper rifles that have 26-inch barrels.

In classical implementations of time sharing, the conventional M-PAM symbols are equally spaced and used with equal probability.

The obtained PPQs exhibited good solubility not only in conventional m-cresol and chloroform, but in the aprotic solvent – N-methyl-2-pyrrolidinone (NMP).

Therefore, a pruned IFFT can be used instead of the conventional M-point IFFT, resulting in a reduction of the computational complexity around 50%.

A new sulfonated diamine monomer, 4,4′-((1,4-phenylenebis methylene))bis(azanediyl))dibenzenesulfonic acid (PMABSA) was synthesized and used as the sole aqueous reactant to fabricate a novel reverse osmosis (RO) membrane with trimesoyl chloride (TMC), in place of conventional m-phenylene diamine (MPD).