Sentence examples for conventional inventory from inspiring English sources

In the control strategy development, conventional inventory control with RD bottom level controlled by manipulating RD bottom flow shows that this process would exhibit multiple steady-states.

Push systems refer to conventional inventory control and scheduling.

In a conventional inventory, normally the variability of the forest attributes at stand level is not always known and therefore less studied [63].

In a conventional inventory, one sample plot (300 500 m2) per each 10 or 15 ha is normally measured with a goal of achieving a maximum acceptable RMSE of 10 15% [60].

As already mentioned, pulse density has a strong influence on the acquisition cost of LiDAR data, and even though the cost for using LiDAR with high or low pulse density might be lower than the cost of a conventional inventory for AGC in fast-growing Eucalyptus plantations, as presented in [32], it will still be highly expensive for a large area.

One of the surveys comprised 100 conventional inventory plots with four strata (operational Planning Units), defined according to age class and thinning status (specifically the four strata were 1998 AC and unthinned; 1979 AC and thinned twice; 1983 AC and thinned twice; and 1983 AC and unthinned) (Table 4).

Airborne LiDAR offers an alternative or supplement to conventional inventories, but despite the possibility of obtaining such remote sensing data, its operational use for broader areas in Central Europe remains experimental.

This represents an advantage over equations that include the mean height because less effort is required in conventional inventories to estimate the dominant height than the mean height of the stand (López Sanchez et al. 2003).

Two of the inventories followed the conventional Forest Inventory and Analysis ("FIA") plot design, that is four clustered subplots, each 168 m2, and spaced 7-m apart [10] (Figure 4).

Two of the inventories followed the conventional Forest Inventory and Analysis ("FIA") plot design, that is four clustered subplots, each 168 m, and spaced 7-m apart [ 10].

Conventional ground inventory methods are time consuming (expensive) and have lower data collection potentials than remote sensing.