Sentence examples for conventional diameter from inspiring English sources

To determine species suitability for afforestation, conventional diameter and height measurements were compared to Relative Growth Rate (RGR) and its underlying components, Net Assimilation Rate (NAR), Specific Leaf Area (SLA) and Leaf Weight Ratio (LWR), as well as the Crop Growth Rate (CGR) as a function of NAR and Leaf Area Index (LAI).

The diameter was less than the conventional diameter for polyomaviruses (45 nm), but the size of viral particles can vary according to the method of fixation and embedding (14 ).

Substrates were prepared from four different types of carbon fibers, two with nanoscale diameters (nanophase, or less than or equal to 100 nm) and two with conventional diameters (or greater than 100 nm).

The authors used conventional fibers (diameter > 100 nm) and nanoscaled fibers (diameter < 100 nm).

The new interface design operated in the stop-flow mode permits the use of conventional analytical diameter HPLC columns, 7.8 mm for SEC and 4.6 mm for RPLC.

This high emission stability was attributed to their stable edge structures, similar to conventional large-diameter MWCNTs.

A conventional fiber, with diameter 125 μm and a glass-covered fiber, with core diameter 20 μm and glass-cover thickness 20 μm, were used as magnetic cores in the fluxgate sensor.

Decreasing side-pore length is concomitant with an increase of the pore diameter (conventional etched samples).

Conventional 40 mm diameter hexagonal "rabbit netting" was not an effective barrier against young independent rabbits and it is recommended that 30 mm hexagonal netting should be used.

Sample KBr was pressed with KBr powder (Acros Organics, Belgium) into a conventional 13 mm diameter disk using Die Kit (PIKE Technologies, USA) and H-62 vacuum press (Trystom, Czech Republic) under 30 kN of pressure for 2 minutes.

From these samples, eleven cross-sections were prepared using different methods: 1. Sample KBr was pressed with KBr powder (Acros Organics, Belgium) into a conventional 13 mm diameter disk using Die Kit (PIKE Technologies, USA) and H-62 vacuum press (Trystom, Czech Republic) under 30 kN of pressure for 2 minutes.