Sentence examples for controller should be from inspiring English sources

According to high importance of power flow control in transmission lines, the proper controller should be robust against uncertainty and disturbance and also have suitable settling time.

By employing results from feedback control theory, the chapter explains how the mesh controller should be designed to minimize the error introduced by the model reduction.

Secondly the multivariable controller should be decentralized to increase the reliability of the control loop.

The droop constant of the ESS controller should be large enough to ensure the controller has enough control bandwidth to compensate for the high-frequency power fluctuation.

Then, for the key technologies of aero-engines switching control, a design algorithm is presented which can determine which candidate controller should be put in feedback with the plant to achieve a desired performance and the procedure to design the aircraft engine multi-loop control system is detailed.

It was shown that the additional control loop with the repetitive controller or additional input variables (currents) of the controller should be used for lowering the THD of the output voltage for the nonlinear load.

In this section, some controllers should be used to control partial nodes for realizing synchronization.

In the following, some controllers should be used to control partial nodes for realizing synchronization.

Therefore, proper controllers should be designed to achieve the goals by adopting some control schemes, such as adaptive control [29], feedback control [30], observer-based control [31], impulsive control [32], intermittent control [33 35], pinning control [36, 37] and so on.

To make VSWTs properly perform the frequency regulation function following specific frequency regulation requirements, supplementary controllers should be designed and integrated into both the existing converter power control loop and the pitch angle control loop to manipulate the corresponding reference set points of torque, active power or rotor speed [12, 13, 14, 15, 16, 17, 18, 19].

More controllers should be hired and trained, with stronger supervision.