Sentence examples for controller requirements from inspiring English sources

Control-relevant identification seeks to both simplify the modelling task and improve the usefulness of the model by taking into account controller requirements during system identification.

A general-purpose application specific integrated circuit (ASIC) chip for the control of switched reluctance machines (SRMs) was designed and validated to fill the gap between the microcontroller capability and the controller requirements of high performance switched reluctance drive (SRD) systems.

A polynomial approach used for the controller synthesis has satisfied control requirements and moreover, it could be used for systems with negative properties such as nonlinearity, non-minimum phase etc. Delta models were used as a external linear model of the nonlinear process.

In order to fulfill numerous control requirements, the linear controllers are cascaded with multiple outer loops that may result in higher bandwidth for the inner controller loops.

Damage-tolerant active control is a recent research area that includes structural damage effect reduction in the controller design requirements.

The proposed design implicitly embeds fault detection and controller elements requirements with considerations to stability and robustness towards uncertainties besides multiple faults environment.

Compared with the existing nonlinear decentralized control approaches, the proposed controller has no requirement for the bounds of interconnections in the power system.

It allows one to tune the PID controller satisfying the requirements to gain or phase margins that is achieved through coordinated selection of tuning rules and test parameters.

An Integrated Modeling, Control and Analysis Framework (IMCA) has been developed and exploited to optimize the articulated arm of Biomass satellite reflector while guaranteeing the existence of a controller fulfilling mission requirements.

Simulation results, from the HIRM automated evaluation procedure are also provided at the end of the paper, from which it is shown that the proposed controller meets the requirements.

Hence, the controller has processing requirements that are proportional to the number of switches in order to carry out flexible flow table management.