Sentence examples for contraction value from inspiring English sources
The results indicate that in cyclic direct shear, the interfaces exhibit cyclic hardening, the interface damping ratio decreased with increasing cycle number and soil relative density, and an interface with a larger particle size has a higher contraction value.
Receiver operating characteristic (ROC) curve analysis was performed to determine the optimal cutoff PV contraction value for prediction of PV-atrial reconnection after ablation.
The mean contraction value was considered as 100% of response.
To obtain the gel contraction value, the relative diameters of the well and the gel were measured using ImageJ software, and the percentage of contraction was calculated using the formula 100× (well diameter−gel diameter)/well diameter.
Substrate stiffening sarcomeres have to generate higher forces in order to keep their contraction value, which again argues for a force generating machinery never working at full load on soft substrates.
Results: Contraction values improved significantly at the end of the first month, compared with the pretreatment values in both groups.
The calculation methods of local contraction values for two kinds of complex curved sail-shaped plates are introduced.
Main Outcome Measures: Maximum and mean contraction values of the vastus medialis and the vastus lateralis muscles were assessed with the biofeedback device.
Mean contraction values in the biofeedback group of the vastus medialis muscles in all 3 monthly measurements, and the vastus lateralis muscles at the end of the first month, were significantly higher than those of the control group.
Within regions of low humidity levels, in addition to the elastic shortening of the prestressed sleepers, the effects of concrete creep and shrinkage could lead to total contraction values in excess of the allowed tolerances for the shoulder width of the sleepers.
The use of new dependence of the core modulus of elasticity on temperature in the ProCAST engineering analysis system makes it possible to simulate deformation processes with 2% deviation of nominal contraction values compared to actual data applied in the machine-building industry.
