The phrase "continuous operation mode" is correct and can be used in written English.
It refers to a state in which something is constantly operating without interruption. An example of using this phrase in a sentence could be: "The factory is set to run in continuous operation mode, ensuring maximum efficiency and productivity."
In the geological factor aspect, the thermal conductivity of the ground material plays a very important role on the GHE performance operating in the continuous operation mode, while its specific heat capacity exerts no appreciable influence.
The reactor used was a stirred tank with an almost flat gas liquid interface of area 67.7×10−4 m2 at 400 rpm, operated in gas-phase continuous operation mode and batchwise for the slurry.
Operating parameters such as membrane area, concentrations and flow rates of the feed and draw solutions were evaluated to determine their influence on water permeate flux, operating pressures, and water recovery in continuous operation mode.
Due to more potential for full scale application the continuous operation mode was recommended.
The efficacy of 30 s TS in batch and continuous operation mode at 60, 65, and 70 °C was studied.
Several municipal primary effluent samples were also treated using the developed FBR system in continuous operation mode.
Short time period of operation, discontinuous of 6 and 12 h operations in a day, and continuous operation modes were applied in the GHE system.
The performance of MCAS systems under on off and continuous operation modes is evaluated and a case study of the newly developed MCAS system in food transportation presented.
For the first time, a direct comparison between MFCs catalyzed by freely-suspended cells, surface-attached cells, and matrix-embedded cells for simultaneous electricity generation and distillery wastewater treatment in both batch and continuous operation modes was systematically performed.
Thereafter, combined adsorption and magnetic separation process studies were conducted in semi-continuous and continuous operations modes whereby Cr VI) loaded PPy Fe3O4 NC particles were continuously isolated from the treated stream using a rare-earth permanent magnet.
These values are about twice those observed for the B1 auto-induction culture, because the biomass formation phase was extended in the continuous fed-batch operation mode and occurred simultaneously with intense protein production during the first 15 h of induction, due to the low induction temperature employed.
