Sentence examples for content by volume from inspiring English sources
The beer is distilled, producing spirits called malt wine, with 50 55 percent alcohol content by volume.
Their product is made with malt and other grains (usually corn or rye), producing a beer that is distilled to make a whiskey of 80 percent alcohol content by volume.
ECC mixture contained 2.6% PVA fibre content by volume.
The first of these, AlcoholVol i, is a measure of the alcohol content by volume for each beer.
Measurements of free vibrations of two beams filled with MRFs differing in the iron particle content by volume were taken in a purpose built experimental set up.
Parametric studies are conducted to examine the effects of CNT content by volume, elastic foundation, skew angle, plate width-to-thickness ratio, plate aspect ratio and boundary conditions on the nonlinear responses of the FG-CNT reinforced composite skew plates.
The Sm cation solution was expanded to 50 ml with ethanol and added into the four Zn cation solutions at the designed Sm contents by volume.
This study investigated the effects of three shaped steel fibers (straight, corrugated, and hooked-end) with different fiber contents by volume (Vf = 0, 1%, 2%, and 3%) on mechanical properties of ultra high performance concrete (UHPC).
The effects of five mix proportioning variables on the material properties are evaluated, which include the water-to-binder ratio (0.24 0.36 by mass), sand-to-binder ratio (0.36 0.66 by mass), fly ash content (60%75%% by mass), polyvinyl alcohol fiber content (1.5%2.2%% by volume), and superplasticizer content (0.10% 0.15% by mass).
The composite rings will be fabricated with a high content (65% by volume) of S2 fiber-glass in an epoxy resin matrix.
Result shows that wicks are successfully fabricated, the optimal wicks are found to be sintered at 700 °C, using cold pressing sintering method, with pore former content 30% by volume; these wicks could reach the porosity of 77.40%, the permeability of 3.15 × 10−13 m2, and have sufficient mechanical strength to meet the machining requirements.
