Sentence examples for contact surface stress from inspiring English sources
On one hand, water has a lubricating effect that modifies the contact surface stress and friction during the test.
The level of the contact surface stresses and the stress distributions for the conventional bone interface were in the same range as previous studies [ 17, 18].
In spite of a very simple shape, a riveted junction has many contact surfaces and stress concentrations that make the local stiffness very difficult to be calculated.
As a result, a neoprene pad was added between the beam and its support to provide a better contact surface and reduce stress concentrations on the bottom bulb of the beam.
It was found that at the contact surface, low tensile stresses close to the accuracy of measurements are formed during solidification.
These procedures greatly simplify both the Muskhelishvili potential and the calculation of direct stresses produced on the contact surface, and, therefore, the stress field in the half-plane is simplified as well.
With an existing three-dimensional finite element contact stress analysis with a prescribed coefficient of friction (COF) along the contact surface, the displacements and stress intensity factors are calculated on the crack leading edge to yield crack propagation trajectories and growth rates.
Optimized fabrication processes have been developed to improve planarization on contact surface and reduce residual stress in switch beams, which ensure a reasonable flat and smooth cantilever and membrane bridge for operation at high RF power and low actuation voltage.
The morphology of the walls and their degree of match, quantified through various approaches, has proved to be an important parameter as regards both normal stress (evolution of the contact surfaces with increasing stress) and shear (evolution of the friction surfaces according to their "angularity").
The simulated results indicated that the smaller area of contact surface yielded higher value of stress in the neck of IGP.
As the asperity entered the rolling contact it acted as a point type contact force, which gave a tensile surface stress in the forward rolling direction.
