Sentence examples for constraint area from inspiring English sources

Considering the frequency allocation in hierarchical networks, a hybrid orthogonal frequency allocation scheme is proposed in [14], which considers about the distance between femtocell and macrocell and the interference constraint area (ILCA) factor.

For the important opposite case where the first ("unconstrained") group was closer to the pedestrian's true location than the second group ("constrained"), it is very improbable that the actual path the user follows in the unconstrained area is consistent with the wall situation of the constraint area.

Figure 2(c) shows that the second card is released from the constraint area of two right fingers. Figure 2(d) shows that the second card is further moved by the left finger and the constraint by the right finger is completely released from two right fingers.

These features have been found as strong elements for mining data in constraint areas.

When the avoidance areas are on the transient path due to the coordinated attitude maneuver command, the maneuver is performed with no violation against the given constraint areas by adopting the navigation function.

The selection of empty rectangle is governed based on the following constraints: area of the rectangle to be placed is less than or equal to the empty rectangle area.

Constraints area applied to the network as upper and lower bounds on the fluxes, (2) α ≤ v ≤ β In which the α vector specifies reaction flux lower bounds and the β vector specifies reaction flux upper bounds.

We call these constraints heterogeneous area constraints.

We laid out a list of constraints, areas for improvement, additional features to add, and began to sketch out initial designs and brainstorm potential mechanisms to raise and lower the solar panels.

Problem studied here is submitted to two constraints (areas of wave tank and overtopping ramp) and two degrees of freedom: ratio between the height and length of ramp (H1/L1) (or ramp slope, β) and distance between the bottom of wave tank and the device (S).

It is shown numerically that the global thermal resistance of the T-shaped construct can be minimized by geometric optimization subjected to constraints, namely, the basement area constraint, the T-shaped fins area fraction constraint and the auxiliary area fraction constraint, i.e. the ratio between the area that circumscribes the T-shaped fin and the basement area.