Sentence examples for constant led from inspiring English sources

Increasing the mass fraction of PEGMA while keeping the total polymer concentration constant led to a decrease in the elastic modulus (E) of the hydrogel, but caused a minimal increase in the swelling ratio (Q).

Removing the effect of CO2 on water use efficiency (by holding CO2 constant) led to average increase of water stress of 22% above the levels observed for the original scenarios.

The detailed analysis of chemical shift and coupling constant led to the determination that compound 2 was elucidated as engleromycenolic acid B. Table 2 1H and 13C NMR spectroscopic data for compounds 2 and 3 Pos.

Worth to mention here is that an increase of the concentration of the detergent to 10 and 25 wt.%, while keeping the concentration of the Au precursor constant, led to a formation of Au nanospheres or spherical shape (Figure 3b,3c) AuNPs with >95% (see Table 1).

In addition, robustness analysis showed that the change of degradation rate constant led to large variations of mRNA copy numbers.

It was noted that polar solvents having a high dielectric constant led to stabilization and high dispersity of the negative charged CNTs and provided a screening effect between the polymeric counterpart, resulting in an increase of the electric and electrochemical properties [ 131].

Starting with the Fekete points a direct minimization process for the Lebesgue constant leads to better results.

Simulated results show that the bending of microrings causes the variation of the propagation constant, leads to the shift of the transmission spectrum, and increases the insertion loss.

It is shown that controlling the shear span or the top rotation while keeping the axial force constant leads to very similar results.

Adding a slight twist during the stacking process, or exchanging one lattice with another that has a different lattice constant, leads to moiré potentials that have a different spatial periodicity.

In the next stage, acceptable increase of the toggling time of chosen functional units (without exceeding the system throughput — the latency is constant) leads to the possibility of decreasing their supply voltages.