Sentence examples for consistent with surface from inspiring English sources

Unfortunately, it turned out that their data set contained several biases that added an artificial cooling trend, and once those were corrected, it was revealed that the lower atmosphere was warming at a rate consistent with surface temperature measurements.

The data were modeled using a 2D inversion algorithm to produce a resistivity model which was consistent with surface geology and seismicity.

This is consistent with surface exposure during the present sea level high-stand, indicates minimal inheritance of ancient cosmogenic nuclides, and is in accord with geomorphic arguments.

The resulting kriged map of surface Ks showed alternating bands of high and low values, consistent with surface structures created by wheel tracks of construction equipment.

The strontium model is consistent with surface complexation reactions fitted to other alkaline earth sorption data to goethite, but could be better refined with data collected over a range of ionic strength.

Thus, corrosion mechanisms in which decuprification predominates are consistent with surface preservation results that indicated low amounts of pitting and limited formation of corrosion scales (Figure 2, Table 2).

The behaviour of the crystal truncation rod (CTR) was fitted using (Andrews & Cowley, 1985 ▶) Fitting revealed = 2.43 0.07, indicating that the grating region has a less than perfect surface, consistent with the surface corrugations observed in periodically poled LN (Rommeveaux, 2002 ▶).

The strike of the upper edge of the fault surface was consistent with the surface traces of active faults.

The near absence of an effect of neutral POPC and approximately equal positive and negative shifts in response to asymmetrically applied −1 charged POPG and POPS to the intracellular and extracellular surfaces, respectively, is consistent with a surface charge voltage offset.

Friction was modeled using a Coulomb stick-slip model with a friction coefficient of 0.25, simulating a satin surface finish for the stem, consistent with the surface finish of the Charnley-Kerboull stems.

The influence of pH on surface roughness quantified by 3D construction of SEM images was consistent with the surface roughness measured by profilometer, which was much more obvious than observation done via a profilometer (Fig. 5).