Sentence examples for connecting rod assembly from inspiring English sources

The loads and boundary conditions obtained from the experiments were used in the finite element model of the connecting rod assembly.

An alternative to labeling the placement of the tie rods is to measure the distance spanned by the tie rod assembly as a whole.

While polyaxial screws facilitate the assembly of the connecting rod, but its ball-in-cup locking mechanism reduces the static compressive bending yield strength as compared with monoaxial screws.

The axle was connected to the inside cylinder assembly by a connecting rod inclined at 1 in 8 to clear the front driving axle.

Finally, some design improvements were suggested for avoid future failures: a gap in the groove length at the connecting rod cap interface, enough to avoid combination of forming laps and higher stress amplitude; increase of the bolt torque assembly to reduce stress amplitude.

Within seconds, as she was roaring down the strip, the connecting rod blew.

Chrysler said "block debris" could cause a connecting rod bearing failure.

Failure of this type of connecting rod was reported to occur at the rounded fillet of the big connecting rod end.

Then the titanium screws and rods would be joined together on each side of the vertebrae, with a connecting rod between them, in the form of an H.

Each connecting rod in an in-line engine or each pair of rods in a V-type engine is attached to a throw of the crankshaft.

connecting rod length to crank radius ratio.